Conversion Kit Check List
This kit will build a 2 to 2-1/2lb boat that will
go nearly 40mph!
|
FunRCBoats Nitro Conversion Kit (good for boats 20" to 36") |
| .15 FP-M, O.S. Engine, water cooled |
| Muffler |
| Motor mount, Aluminum |
| Flywheel |
| Water intake, brass |
| Water exit, brass |
| Epoxy Paint, Clear to fuel proof hull |
| Stainless Hardware, bolts, washers and nuts |
| .130" dia. Flex Drive shaft, teflon tube, drive dog, thrust bearing, nut (pre joined) |
| Prop, Octura X430+ |
| FunRCBoats custom Steering strut |
| Mounting Hinge |
| Waterproof Grease, 1oz |
| Exhaust extension tube, silicone 3/8" dia. |
| Throttle cable and clasp |
| Starter belt, 17" |
| Steering linkage and silicone boots |
| Instant Glue, 1oz |
| Silicon Tubing, water, LG |
| Silicon Tubing, Fuel, SM |
| Fuel Tank, 6oz |
| Flex drive collar, M5x.8 to .130 |
| Installation Instructions |
|
Conversion cost estimate: $199.00 |
Please Note:
although this comes with virtually everything you need to convert your boat to a
nitro inboard. You will need the following:
Parts to operate: Servo to operate throttle, 12V
hand held
starter, 12V-7Ah gell cell battery,
Fuel (20-60%),
Glow Starter and
fuel pump or
Bulb and Recovery "device" if
your boat were to stall while on water.
Tools to assemble: Drill, bits, Screw
drivers, Dremel, Hex key wrenches, needle nose pliers, 5 minute epoxy and Exacto knife.
All of these items are listed in our online store. However, if you need a conversion kit for a bigger boat or want a custom kit Contact us!